Heating Repair & Installation in Dallas, TX
Furnaces, heat pumps, and complete heating systems for homes and businesses across DFW
Furnace & Heat Pump Repair in Dallas-Fort Worth
North Texas winters are short but sharp — and a hard freeze is exactly when heating systems fail. Whether you run a gas furnace, an electric furnace, or a heat pump, our licensed technicians find the fault fast and quote the fix up front.
Common heating problems we fix
- Furnace blowing cold air or not igniting
- Faulty igniters, flame sensors, and gas valves
- Heat pumps stuck in defrost or not switching modes
- Blower motor and limit switch failures
- Thermostat and zoning problems
- Strange noises, burning smells, or frequent cycling
- Carbon monoxide safety inspections
Furnace acting up? Start with our guide: Furnace blowing cold air? 6 things to check before you call.
Request a Free Estimate
Heating Installation & Replacement
If your furnace is past 15 years old or repairs are getting expensive, a modern high-efficiency system often pays for itself in lower utility bills. We install gas furnaces, electric furnaces, and heat pump systems — sized correctly for your home with a proper load calculation, never a guess.
Every installation includes
- Load calculation and honest sizing recommendation
- Gas furnace, electric, and heat pump options
- Removal and disposal of old equipment
- Combustion safety and airflow testing at startup
- Thermostat setup and system walkthrough
Brands we install and service
Call (469) 583-8741
Heating Tune-Ups & Maintenance
A fall tune-up is the cheapest heating repair you'll ever buy. We clean burners, test ignition and safety controls, check heat exchangers for cracks, verify gas pressure, and make sure your system is ready before the first cold front rolls through DFW. Annual maintenance also keeps most manufacturer warranties valid.
Stay Warm This Winter
Get a free estimate on heating repair, replacement, or a seasonal tune-up anywhere in the DFW metroplex.